LambdaLab - Sample Preparation                     Home


For C518 testing:
    Non-loose-fill materials should be cut as a single 12" x 12" piece, with parallel faces.

For C-177 testing:
    Non-loose-fill materials should be cut as 2 - 12"x12" pieces, with parallel faces.

If material is less than 0.5” thick, supply enough pieces to lay up to at least 0.5” thick.
Loose-fill material may require additional setup time.
Material which outgasses or otherwise ages soon after manufacture should reach equilibrium before shipping.
Contact us if you have special material requirements.